Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums
Filter by: Last 24 Hours Clear All
  • zaza's Avatar
    Yesterday, 11:59 PM
    zaza replied to a thread ransome ts 80 in Classic Machinery
    Frankly I wouldn't bother fitting any grease nipples. If you disconnect the turnover linkage and undo the castellated nut at the front of the pinion...
    33 replies | 2438 view(s)
  • aleary's Avatar
    Yesterday, 11:18 PM
    aleary replied to a thread ransome ts 80 in Classic Machinery
    fitting a grease nipple to the headstock is a good idea, is it an easy job to remove the headstock, looking at the drawing from the book there are a...
    33 replies | 2438 view(s)
  • zaza's Avatar
    Yesterday, 06:20 PM
    zaza replied to a thread ransome ts 80 in Classic Machinery
    I do think you are probably right FF about there being no nipples to grease the pinion shaft, I can't remember greasing any in that area anyway....
    33 replies | 2438 view(s)
  • Footsfitter's Avatar
    Yesterday, 05:36 PM
    Can't ever remember a grease nipple on any of these Ransome era plough turnover shafts, but I do recall there would of been a cap on covering the...
    33 replies | 2438 view(s)
  • zaza's Avatar
    Yesterday, 05:02 PM
    zaza replied to a thread ransome ts 80 in Classic Machinery
    Just realised that you asked about using a flap disc on a grinder. I've never used one of those but it's worth a try. I would prefer using a wire...
    33 replies | 2438 view(s)
  • zaza's Avatar
    Yesterday, 10:46 AM
    zaza replied to a thread ransome ts 80 in Classic Machinery
    It will be up to you how wide your ploughed furrow is going to be because it is a single furrow plough. On mult-furrow ploughs that distance is...
    33 replies | 2438 view(s)
No More Results