Activity Stream

I do think you are probably right FF about there being no nipples to grease the pinion shaft, I can't remember greasing any in that area anyway....

Can't ever remember a grease nipple on any of these Ransome era plough turnover shafts, but I do recall there would of been a cap on covering the...

Just realised that you asked about using a flap disc on a grinder. I've never used one of those but it's worth a try. I would prefer using a wire...

It will be up to you how wide your ploughed furrow is going to be because it is a single furrow plough. On mult-furrow ploughs that distance is...

ACE would be the best guide to this particular machine. Having bought a new pump I personally would only reuse the old "new oil" if I had access a...

ok so when i have the furrow width adjusted correctly i should have ploughed a furrow approx 12" wide? got a few jobs to do before i can try it out...

I expect if its the standard velvet shift it'll be just a switch on the F-R lever on the opposite side to where the control cable fits on a lever on...

You can tell that the top link is too short and it means that the plough isn't level fore/aft. I would adjust the top link so that the plough is...

managed to turn some soil over with the plough and got it turning over better to. my lift arms wont go high enough, took the fixed lift arm apart...

Your last sentence sums it up I guess. Thanks for the advice will have a go on Monday - will put battery on a recon' cycle on the charger - It is a...

Twp possible reasons for this that come to mind immediately. Does the plough "not quite make it over on both sides" ? i.e. does it tend to catch one...

- that sounds like the starter is engaged with the ring gear. (A-B just worked the solenoid making that clunk) Try turning the crankshaft pulley...

i managed to have a look at the plough today, i made a new linkage for the turnover, i tried it with a light length of round bar but it broke...

Thanks for the replies and advice Battery 12.8v across the terminals - can see no "fizzing" when turning the key Since it's a new starter...

So is the battery charged? what makes you say "its good?" Simplest "test" is to see what the starter does- This is the end view of...

If it was me, I would first verify the battery cables (both ends), especially the ground as poor current make it seem like there was a bad battery...

Are you sure its not your joints? A wee drop of 3 in one.

I was always told they squeak until you have paid the cobbler :)

have you tried turning the adjuster both ways?they can be very tight

also i think you check the rear end oil with the engine ticking over

There should be a Nato Stock Number (NSN) on that black plate. googling that might reveal all!

Its not LEDs as such is the way they are powered, there will be the control unit built into them that pulses them on and off at about 100Hz, this is...

cheers but I was lucky enough to get a set of paper ones with the tractor that seem pretty detailed. Injector pump drive seal went at the weekend...

Sorry, SOLD

Hello,i have the same problem, Where i can find the fuse ?