Tab Content
  • ACE's Avatar
    19-01-18, 10:21 AM
    ACE replied to a thread Manitou warning lamp in Machinery
    Hello Yes as footfitter said follow link to website for contact details. or post 5 or 6 messages on here somewhere and I think private messages...
    7 replies | 174 view(s)
  • ACE's Avatar
    16-01-18, 10:22 PM
    ACE replied to a thread Manitou warning lamp in Machinery
    Its low brake fluid level. take left hand dash panel off and have a look, could be iffy sensor in cap. if its low and its not the master cylinder...
    7 replies | 174 view(s)
  • ACE's Avatar
    14-01-18, 05:28 PM
    ACE replied to a thread Manitou 627 Hub Issue in Machinery
    Drain/Level and filler bungs you mean on axle? if you look closer there are 3 drain bungs, 1 in the centre and 2 underneath one each side. ...
    11 replies | 379 view(s)
  • ACE's Avatar
    14-01-18, 05:22 PM
    ACE replied to a thread Manitou 627 Hub Issue in Machinery
    The oil I recommend is genuine Manitou oil "special wet brake lubricant" there are other oil brands that claim to do the job but they don't always...
    11 replies | 379 view(s)
  • ACE's Avatar
    14-01-18, 12:43 AM
    ACE replied to a thread Manitou 627 Hub Issue in Machinery
    May have been limited slip diff in front axle or brakes? An oil change using genuine Manitou axle oil will normally cure that. Oil in hubs isn't to...
    11 replies | 379 view(s)
  • ACE's Avatar
    12-01-18, 08:47 PM
    ACE replied to a thread Manitou 627 Hub Issue in Machinery
    Hello Obviously check oil level but if it making a noise chances are it needs alot more than just oil. Jack it up check play on wheel bearings...
    11 replies | 379 view(s)
  • ACE's Avatar
    12-01-18, 08:42 PM
    ACE replied to a thread Manitou 627 Hub Issue in Machinery
    I'm here ;) just busy
    11 replies | 379 view(s)
  • ACE's Avatar
    03-01-18, 01:03 AM
    ACE replied to a thread Deutz starter in Machinery
    Found a 4kw iskra, send you a PM:) Edit oh I cant cause your new and they not switched on. its expensive just over 300 plus vat, if your...
    2 replies | 219 view(s)
  • ACE's Avatar
    02-01-18, 08:22 PM
    ACE replied to a thread Deutz starter in Machinery
    Probably i will have a look this evening.
    2 replies | 219 view(s)
No More Results
About jd69

Basic Information

About jd69
Location:
scotland

Statistics


Total Posts
Total Posts
109
Posts Per Day
0.06
General Information
Last Activity
24-02-17 10:03 PM
Join Date
10-04-13
Referrals
0

2 Friends

  1. ACE ACE is offline

    Senior Member

    ACE
  2. Emily Emily is offline

    Junior Member

    Emily
Showing Friends 1 to 2 of 2