Tab Content
  • ACE's Avatar
    Yesterday, 07:07 PM
    ACE replied to a thread Matbro 250 110 in Machinery
    Sounds about right. Probably faulty pressure switch on gearbox. Switch for warning light is seprate to gauge. Its underneath mounted remotely of...
    3 replies | 178 view(s)
  • ACE's Avatar
    15-10-18, 08:26 AM
    ACE replied to a thread Matbro 250 110 in Machinery
    What does the gauge indicate? Might be faulty warning light sender. Gauge works off a different sender unit although never accurate but gives a rough...
    3 replies | 178 view(s)
  • ACE's Avatar
    11-10-18, 07:16 AM
    ACE replied to a thread Jcb Perkins presurising in Machinery
    You should check transmission cooler too cause if thats blocked it will stop coolent flow too.
    23 replies | 1291 view(s)
  • ACE's Avatar
    11-10-18, 07:14 AM
    ACE replied to a thread Jcb Perkins presurising in Machinery
    Be too late then damage already be done. Golden rule Fix the cause not just the fault.
    23 replies | 1291 view(s)
  • ACE's Avatar
    10-10-18, 06:39 PM
    ACE replied to a thread Jcb Perkins presurising in Machinery
    Second above. Rad is generally the cause of most head gasket issues one way or another. Spend several hours cleaning rads some times and still not...
    23 replies | 1291 view(s)
  • T P's Avatar
    10-10-18, 10:48 AM
    T P replied to a thread Jcb Perkins presurising in Machinery
    If it does it again_ I'd recommend pulling the radiator out and having it flow tested by someone competent. If there is insufficient flow top to...
    23 replies | 1291 view(s)
  • ACE's Avatar
    09-10-18, 06:49 PM
    ACE replied to a thread Jcb Perkins presurising in Machinery
    7mm!!! Thats hell of a lot! Your valves will hit the pistons when they open i think! Oh yeah check head bolts for stretch, as this could be the...
    23 replies | 1291 view(s)
  • T P's Avatar
    07-10-18, 07:04 AM
    T P replied to a thread Jcb Perkins presurising in Machinery
    Assuming it is Ace indicated is an 1100 series from page 58 of the manual: If someone has lost the locating dowels for the gasket (seen that,...
    23 replies | 1291 view(s)
  • ACE's Avatar
    06-10-18, 07:46 AM
    ACE replied to a thread Jcb Perkins presurising in Machinery
    I think these were bad for expansion tank leaking on the plastic weld seam were the 2 halves join. You sure its not just that? Thermostat does...
    23 replies | 1291 view(s)
  • T P's Avatar
    29-09-18, 10:18 PM
    If it's an old thing walk away the old ones weren't very good to start with never mind additional issues. Can't comment on the recent ones.
    3 replies | 438 view(s)
No More Results
About T P

Basic Information

About T P
Location:
The muddy edge of the biggest puddle in the uk

Statistics


Total Posts
Total Posts
672
Posts Per Day
0.32
General Information
Last Activity
Yesterday 08:47 PM
Join Date
16-02-13
Referrals
0

1 Friend

  1. ACE ACE is offline

    Senior Member

    ACE
Showing Friends 1 to 1 of 1