• ACE's Avatar
    Yesterday, 10:20 AM
    Hi TP MLA 627 and MLA 628 have a diode on the reverse light circuit under the left hand side of dash. normally just about access it through the...
    9 replies | 2276 view(s)
  • Footsfitter's Avatar
    Yesterday, 08:05 AM
    Footsfitter replied to a thread New Holland 8560 in Machinery
    Here a photo from the M/60series manual showing the checklist for no lift arm movement run through that lot and come back with the result.
    3 replies | 112 view(s)
  • Footsfitter's Avatar
    17-09-17, 06:33 PM
    Footsfitter replied to a thread Iceland in Photos
    I guess he was doing a bit of "summer maintenance" It was just parked up there waiting for the next lot of gullible tourists. Iceland promote...
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    17-09-17, 05:57 PM
    Footsfitter replied to a thread Iceland in Photos
    He's brave going up there! We went to the only one you can drive up to, once up there its very apparent how cold the wind is over the ice & snow. get...
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    17-09-17, 05:48 PM
    Footsfitter replied to a thread Iceland in Photos
    They do have some new forests, one right near Geysir where after a quick look at that we then drove through a narrow stone track in the relatively...
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    16-09-17, 11:57 PM
    Footsfitter replied to a thread Iceland in Photos
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    16-09-17, 11:53 PM
    Footsfitter replied to a thread Iceland in Photos
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    16-09-17, 11:51 PM
    Footsfitter replied to a thread Iceland in Photos
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    16-09-17, 11:49 PM
    Footsfitter replied to a thread Iceland in Photos
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    16-09-17, 11:46 PM
    Footsfitter replied to a thread Iceland in Photos
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    16-09-17, 11:43 PM
    Footsfitter replied to a thread Iceland in Photos
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    16-09-17, 11:37 PM
    Footsfitter started a thread Iceland in Photos
    Never thought I would end up in Iceland nor be taking a few agricultural snaps but 2 weeks ago it was time to fly to Reykjavik and meet up with my 15...
    12 replies | 185 view(s)
  • Footsfitter's Avatar
    16-09-17, 08:19 PM
    Footsfitter replied to a thread Compressor problem in Machinery
    Well done! thats a result, even though its old they were a good simple machine. I have the shop manual here at home but things have been hectic...
    16 replies | 888 view(s)
  • Footsfitter's Avatar
    16-09-17, 08:11 PM
    Footsfitter replied to a thread ford 7600 hydraulics in Machinery
    Tried looking for a 4cylinder hydraulic top cover showing the underside- there's some linkages there for both the raise and lower lever and also the...
    9 replies | 344 view(s)
  • Footsfitter's Avatar
    12-09-17, 11:56 PM
    Footsfitter replied to a thread ford 7600 hydraulics in Machinery
    Doesn't sound too promising. Obviously you have enough oil in the backend? is it just the single transmission mounted pump? or does it have the...
    9 replies | 344 view(s)
  • Footsfitter's Avatar
    11-09-17, 08:14 PM
    Footsfitter replied to a thread ford 7600 hydraulics in Machinery
    Thought afterwards, but by your answer it sounds like you have the 3 position "valve", the other setup would be the single or double spool valve with...
    9 replies | 344 view(s)
  • Footsfitter's Avatar
    10-09-17, 05:47 PM
    Footsfitter replied to a thread ford 7600 hydraulics in Machinery
    Welcome. Is your tractor a 7600 or a 7610 series? When I read it first I assumed its going to be a classic 10 series back end pump failure but...
    9 replies | 344 view(s)
  • Footsfitter's Avatar
    09-09-17, 09:12 PM
    Footsfitter replied to a thread Sharp clutch mf6465 in Machinery
    I'm led to believe that newer models than our 6400 series have simplified the problem of ID'ing the faulty switch because all of the switches are now...
    5 replies | 379 view(s)
  • ACE's Avatar
    08-09-17, 07:12 AM
    ACE replied to a thread manitou 526 in Machinery
    Known issue. Its just weak area and driver abuse. There is a mod kit from manitou for persistant offenders! To add in a seperate inline relief valve...
    5 replies | 1780 view(s)
  • Footsfitter's Avatar
    06-09-17, 11:21 PM
    Can't remember the 8560 we had but I expect it may be the same. On the TM's there is a group of black earth wires attached to the spool block casting...
    8 replies | 2366 view(s)
  • Footsfitter's Avatar
    05-09-17, 09:43 PM
    Footsfitter replied to a thread jcb 409 in Machinery
    Has it permanent 4wd (possible) or even a differential between front and rear axles (unlikely) ? Rule of thumb if its 4wd all the time is that...
    3 replies | 190 view(s)
  • Footsfitter's Avatar
    03-09-17, 07:22 PM
    http://tinyurl.com/y9z63sfw Basingstoke
    4 replies | 240 view(s)
  • Footsfitter's Avatar
    03-09-17, 01:08 AM
    UK models IIRC had a hand priming pump on top of a filter? - round metal thing with a black knob to press, the actual "lift pump" is in the injection...
    10 replies | 409 view(s)
  • Footsfitter's Avatar
    30-08-17, 07:49 PM
    With it being harvest time most people are too busy with important issues, besides I'm guessing your on about a wainroy IH digger/loader? which could...
    5 replies | 619 view(s)
  • Footsfitter's Avatar
    24-08-17, 12:33 PM
    Looking at that brochure, I can just make out the lines of the cannisters grooves in the cutaway picture, but interestingly I reckon that the saucer...
    12 replies | 538 view(s)
  • Footsfitter's Avatar
    24-08-17, 10:00 AM
    Hello John, Had a look and can now see what you are on about! Its the can with the lines/grooves in its top? Only seen these on TD5 landrover...
    12 replies | 538 view(s)
  • Footsfitter's Avatar
    22-08-17, 11:30 PM
    Footsfitter replied to a thread Catch-up in Workshop Projects
    Lifting the box up from underneath, then major job working out exactly how the new heat jacket would fit. I suppose there might be a modification...
    3 replies | 595 view(s)
More Activity
About Footsfitter

Basic Information

About Footsfitter
Location:
Basingstoke, Hants

Signature


The best thing about Facebook is the logout button......

Statistics


Total Posts
Total Posts
2,378
Posts Per Day
1.42
General Information
Join Date
15-02-13
Referrals
4

2 Friends

  1. ACE ACE is offline

    Senior Member

    ACE
  2. ploughman24 ploughman24 is offline

    Junior Member

    ploughman24
Showing Friends 1 to 2 of 2