Search:

Type: Posts; User: ACE

Page 1 of 20 1 2 3 4

Search: Search took 0.28 seconds.

  1. Replies
    5
    Views
    328

    Re: Sanderson teleporter 6-22 hydraulics

    Yes steering valve had a 1/4 hose with jic ends to the orbital unit as a load sense line to tell valve when to send oil to steering. Steer valve or proirity valve was a danfoss on these very reliable...
  2. Replies
    5
    Views
    328

    Re: Sanderson teleporter 6-22 hydraulics

    Very little bsp on sandersons. Mostly JIC for hoses. The threads on some rams are bsp with adaptors to jic for hoses.
  3. Replies
    11
    Views
    894

    Re: Sanderson teleporter2 6.22 what type oil?

    No but there simple enough what the problem?
  4. Re: Terex 250 doing nothing after changing hydraulic oil?

    Pipe you want to take off is about 3/4" size. I wouldnt expect oil to flow out of pump on pressure side with out it turning so you may have fooked it!
  5. Re: Terex 250 doing nothing after changing hydraulic oil?

    Pump is high on these so will need bleeding.

    Take the main pressure outlet pipe of the pump. Crank it over on starter with the fuel solenoid disconnect so it wont start. Pressure in the tank will...
  6. Replies
    5
    Views
    668

    Re: Manitou 527 dash lights

    So long as you had ignition on or was running then yes alternator fudged. Turbo exhaust not filling it with soot? That kills them early.

    Can send you an alternator on monday if you want. PM me.
  7. Replies
    5
    Views
    668

    Re: Manitou 527 dash lights

    Well first thoughts are the alternator.

    Pull the small wire out of the alternator plug all them lights should go out running or not.

    If they dont then you will have that wire rubbed through to...
  8. Replies
    2
    Views
    560

    Re: Matbro TS 290 hi-torque transsmision oil

    Its ATF dextron 2 or 3.

    Its pink cause its got water in it which will be the oil cooler under the radiator.

    Replace it and flush oil out. Water will damage the clutch packs.
  9. Thread: Matbro 250 110

    by ACE
    Replies
    3
    Views
    836

    Re: Matbro 250 110

    Sounds about right. Probably faulty pressure switch on gearbox. Switch for warning light is seprate to gauge.
    Its underneath mounted remotely of transmission i think. Just in front of the rear axle ...
  10. Thread: Matbro 250 110

    by ACE
    Replies
    3
    Views
    836

    Re: Matbro 250 110

    What does the gauge indicate? Might be faulty warning light sender. Gauge works off a different sender unit although never accurate but gives a rough idea.
  11. Replies
    23
    Views
    2,689

    Re: Jcb Perkins presurising

    You should check transmission cooler too cause if thats blocked it will stop coolent flow too.
  12. Replies
    23
    Views
    2,689

    Re: Jcb Perkins presurising

    Be too late then damage already be done. Golden rule Fix the cause not just the fault.
  13. Replies
    23
    Views
    2,689

    Re: Jcb Perkins presurising

    Second above. Rad is generally the cause of most head gasket issues one way or another.
    Spend several hours cleaning rads some times and still not get them 100% clean.
  14. Replies
    23
    Views
    2,689

    Re: Jcb Perkins presurising

    7mm!!! Thats hell of a lot! Your valves will hit the pistons when they open i think!

    Oh yeah check head bolts for stretch, as this could be the 3rd time they been used they could well be scrap....
  15. Replies
    23
    Views
    2,689

    Re: Jcb Perkins presurising

    I think these were bad for expansion tank leaking on the plastic weld seam were the 2 halves join. You sure its not just that?

    Thermostat does close off the bypass and for what they cost just...
  16. Replies
    11
    Views
    894

    Re: Sanderson teleporter2 6.22 what type oil?

    Your T2 had limited slip diffs believe it or not they just didnt work very well😂
  17. Replies
    11
    Views
    894

    Re: Sanderson teleporter2 6.22 what type oil?

    It was there tech dept that told me xep90 was more automotive grade and the terrain was heavy duty industrial/commercial and a match for fuches titan ls90.
  18. Replies
    11
    Views
    894

    Re: Sanderson teleporter2 6.22 what type oil?

    Q8 site is wrong. Even the early ones with dry brakes had limited slip diffs so need a limited slip 90 grade oil.
  19. Replies
    11
    Views
    894

    Re: Sanderson teleporter2 6.22 what type oil?

    Hello
    The only oil you want to use in axles on your sanderson is LS90 limited slip.
    Like morris terrian LS or Fuches titan ls90
    Do not use this morris xep 90 its a light duty ls90 for cars.
    ...
  20. Replies
    4
    Views
    1,380

    Re: Manitou LSU "fault"

    To be fair i would have sent you off on a wild goose chase cause i not had one do that yet! Your driver must have some grubby hands!

    You sure that 90 deg gearbox is okay? Think you should buy one...
  21. Thread: Manitou mlt 526

    by ACE
    Replies
    4
    Views
    512

    Re: Manitou mlt 526

    Just put genuine manitou special wet brake oil in it and problem will go away.

    Older clark hurth axles need the LS90 not the later dana spicer axles.
  22. Thread: jcb 4cx help

    by ACE
    Replies
    1
    Views
    257

    Re: jcb 4cx help

    Fuse
    Handbrake switch
    Oil level
  23. Replies
    17
    Views
    2,007

    Re: JCB 3CX - 1986 - Battery not chargung

    Lucas starters are rubbish. There either cheap copies or poor quality Indian built. Indian company bought lucas electrical years ago!

    Check transmission oil if that milky then the transmission oil...
  24. Replies
    17
    Views
    2,007

    Re: JCB 3CX - 1986 - Battery not chargung

    Anyway. Charging circuit.

    Alternator has 1 possibly 2 heavy wires coming off it on a terminal called B+ (battery live) these wires normally go back and connect to poisitive on starter motor or in...
  25. Replies
    17
    Views
    2,007

    Re: JCB 3CX - 1986 - Battery not chargung

    I always get suspicious of starting problems when people say they had a new starter motor:undecided:

    From you story i interpret the following!

    Had starting problem caused by old worn out...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4