Search:

Type: Posts; User: ACE

Page 1 of 20 1 2 3 4

Search: Search took 0.14 seconds.

  1. Replies
    9
    Views
    349

    Re: Sanderson teleporter2 6.22 what type oil?

    Your T2 had limited slip diffs believe it or not they just didnt work very well😂
  2. Replies
    9
    Views
    349

    Re: Sanderson teleporter2 6.22 what type oil?

    It was there tech dept that told me xep90 was more automotive grade and the terrain was heavy duty industrial/commercial and a match for fuches titan ls90.
  3. Replies
    9
    Views
    349

    Re: Sanderson teleporter2 6.22 what type oil?

    Q8 site is wrong. Even the early ones with dry brakes had limited slip diffs so need a limited slip 90 grade oil.
  4. Replies
    9
    Views
    349

    Re: Sanderson teleporter2 6.22 what type oil?

    Hello
    The only oil you want to use in axles on your sanderson is LS90 limited slip.
    Like morris terrian LS or Fuches titan ls90
    Do not use this morris xep 90 its a light duty ls90 for cars.
    ...
  5. Replies
    4
    Views
    547

    Re: Manitou LSU "fault"

    To be fair i would have sent you off on a wild goose chase cause i not had one do that yet! Your driver must have some grubby hands!

    You sure that 90 deg gearbox is okay? Think you should buy one...
  6. Thread: Manitou mlt 526

    by ACE
    Replies
    4
    Views
    365

    Re: Manitou mlt 526

    Just put genuine manitou special wet brake oil in it and problem will go away.

    Older clark hurth axles need the LS90 not the later dana spicer axles.
  7. Thread: jcb 4cx help

    by ACE
    Replies
    1
    Views
    184

    Re: jcb 4cx help

    Fuse
    Handbrake switch
    Oil level
  8. Replies
    17
    Views
    1,553

    Re: JCB 3CX - 1986 - Battery not chargung

    Lucas starters are rubbish. There either cheap copies or poor quality Indian built. Indian company bought lucas electrical years ago!

    Check transmission oil if that milky then the transmission oil...
  9. Replies
    17
    Views
    1,553

    Re: JCB 3CX - 1986 - Battery not chargung

    Anyway. Charging circuit.

    Alternator has 1 possibly 2 heavy wires coming off it on a terminal called B+ (battery live) these wires normally go back and connect to poisitive on starter motor or in...
  10. Replies
    17
    Views
    1,553

    Re: JCB 3CX - 1986 - Battery not chargung

    I always get suspicious of starting problems when people say they had a new starter motor:undecided:

    From you story i interpret the following!

    Had starting problem caused by old worn out...
  11. Replies
    6
    Views
    687

    Re: Manitou 735 PS with gear shift's problem

    A call to manitou France then. Sounds very poor imo.
  12. Replies
    6
    Views
    687

    Re: Manitou 735 PS with gear shift's problem

    Common clutch to forwards 1 and 3 is forward low pack.

    The solenoid that operates this pack is at the top of box nearest front and cab side.

    I would say if you lost reverse too then you need to...
  13. Thread: Manitou 627

    by ACE
    Replies
    4
    Views
    661

    Re: Manitou 627

    Have you replaced the right temp sender?
    There are 2 right next to each other.
    One sends signal to solenoid under fuel injector pump to change timing.

    Other one is the temp gauge. I think temp...
  14. Replies
    6
    Views
    687

    Re: Manitou 735 PS with gear shift's problem

    Actually i think i would be calling the manitou importer for Denmark and complaining! Can have transmission out on the floor in 4 or 5 hrs! So 10hrs looking at it is a joke.
  15. Replies
    6
    Views
    687

    Re: Manitou 735 PS with gear shift's problem

    10hours and a main dealer doesnt know whats wrong with it:eek: shouldnt take more than an 1 hour to figure out if its electric or internal and test relevent clutch pack pressure.

    I surgest you...
  16. Re: Hydrostatic yard Forklifts , Linde 391 any good or nightmare reliability wise.

    You could also look at manitou msi25 or msi30 or jcb teletruck. There all hydrostatic as well.
  17. Thread: Manitou 627

    by ACE
    Replies
    4
    Views
    661

    Re: Manitou 627

    Rev coumter works off alternator. Prone to eating alternator belts.

    Could be alternator fault.
    Next to radiator are some maga fuses for alternator and ignition/glow plugs, the alternator one...
  18. Re: JCB 3cx Contractor Powershift Transmission problem

    I have stopped using the for overhauls now. Had nothing but hassle with them and problems. Just not good enough when they charge top price i want it spot on no exceptions and definatly no bull crap...
  19. Re: JCB 3cx Contractor Powershift Transmission problem

    I agree with you FF. knackered seals or cracked clutch pack drum letting pressure from one side to the other when hot as the crack pens up?

    f/r lever would play up regardless of temp, and to an...
  20. Replies
    3
    Views
    728

    Re: Matbro 250 110 engine

    the common hidden places on the engine to leak are the timing case gasket to block just behind the fuel injector pump, and the oil cooler on the side of the block above the starter motor has a rubber...
  21. Re: Caterpillar Telehandler Th62,63, 82, 83, 012 & 103 Trasmission Fault Finding

    Hello

    Sorry for the late reply, please see the incredibly small picture attached! hope you can zoom in!

    This is the solenoid sequence for the T12000 box as used in a Manitou and matbro handler,...
  22. Re: Caterpillar Telehandler Th62,63, 82, 83, 012 & 103 Trasmission Fault Finding

    Its a good old clark hurth T12000. I do check in here fairly regular but missed this post.
  23. Replies
    3
    Views
    728

    Re: Matbro 250 110 engine

    Cab off be easier. Unless you need to do sump gasket and or timing case gaskets etc.

    Did rear crank seal, flywheel ring gear and drive coupling a few years ago on one while I had the cab off,...
  24. Thread: Valve block

    by ACE
    Replies
    8
    Views
    1,798

    Re: Valve block

    Hello

    Yes still got one.

    Follow link in signiture as footsfitter mentioned.:)
  25. Replies
    2
    Views
    521

    Re: Matbro tr250 110 door handles

    The plastic outer handle? Yes I have 3 of them in stock:)

    Follow the link on my signature. (bottom of this post)
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4