Search:

Type: Posts; User: Humfy

Page 1 of 6 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    745

    Re: Mf 54 series lighting problem

    Thats what caught me out, there are actually 3 fuses for it, one for all dashboard illumination, and one for each opposing side.

    It was when i connected a trailer board and noticed it wasnt...
  2. Replies
    3
    Views
    745

    Mf 54 series lighting problem

    Hello there,

    just wondering if any of you guys have come accros an issue with rear side lights on a MF 54 series, ive lost the power to the left side which affecting the left tail & trailer cct. ...
  3. Replies
    1
    Views
    880

    Re: Massey 2008 5455 blower fan

    Hello there, its highly likely its the switch which selects the fan speed. In higher speed settings it fails quickly. They are very cheap but you will have to look on auction sites etc, believe...
  4. Replies
    2
    Views
    966

    Re: Massey ferguson 6465

    Iv seen a few issues with MF switches of late, usually about 10yrs old they start to play up. i know youv replaced switch, but id un plug etc and make sure connnections are good and no...
  5. Replies
    4
    Views
    1,736

    Re: Massey ferguson 390

    If its an older well used machine, might be worth checking the hydraulic fittings on loader. Iv seen similar a few times where pin on male fitting been damaged/worn which restricts oil flow. ...
  6. Thread: 2004 JCB 530-70

    by Humfy
    Replies
    5
    Views
    2,315

    Re: 2004 JCB 530-70

    I had a jcb tele yrs ago for a spell, theyr pretty bomb proof things. Another thing worth checking is solenoid correct voltage, just in case its bern replace with a spare etc. Most these type...
  7. Thread: 2004 JCB 530-70

    by Humfy
    Replies
    5
    Views
    2,315

    Re: 2004 JCB 530-70

    Hello there, try and find solenoid for boom, it will have a black plug on it, unplug and connect a multimeter 12v dc scale and then try switch, if it reads 12v whilst switch on then immediately drops...
  8. Replies
    1
    Views
    1,656

    Re: JCB sitemaster ignition problems

    Hello there,

    read your post other week and it does seem an odd one, one thing perhaps worth checking tho is that earth connections within cab/fusebox all nice n clean/secure, things switching on...
  9. Replies
    0
    Views
    1,036

    MF 54 series shuttle problem

    Hello there, iv got an issue with my MF5455 where “shuttle/transmission” keeps playing up ie either dropping out with fwd/rev lights flashing on/off etc. Its pretty random but very annoying usually...
  10. Replies
    0
    Views
    1,160

    MF5455 transmission/interlock problem

    Hello there, still got an issue with transmission to engage, tractor starts fine etc so im assuming cluct switch ok, but both fowrd & reverse indicators flash/toggle on & off and transmission will...
  11. Replies
    6
    Views
    3,234

    Re: Massey 6485 Transmission error

    Just reading your issue there, iv a mf5455 & hade an issue similar to this other day, tractor actually went in reverse rather than fwds before drive failed altogether, tried it a few times etc just...
  12. Replies
    0
    Views
    878

    MF5455 shuttle problem

    Hello there, just had a strange one with MF 5455, was working fine yesterday, started up this morning, shuttle to fwd select, & travtor went in reverse, would not even select fwd , then noticed the...
  13. Replies
    1
    Views
    1,316

    Re: Solenoid valve cleaning

    Iv no experience of them on a ford, but generally the mechanical part should be well lubricated with the oil circuit it is in, thers little to actually service in the electrical part as all moving...
  14. Re: Mf 5455 rear linkage problem with mower conditioner

    Wish id noticed your comment sooner..... bought a complete set up from a breaker, but even after asking for good parts, one of arms was well worn, fortunately it was opposite side to my original so...
  15. Re: Mf 5455 rear linkage problem with mower conditioner

    Had a closer look & splines worn badly on right side, im suspecting tractor had a big hedgecutter on it before i took ownership . Its an expensive repair to.
    Joys , much apprecited for...
  16. Re: Mf 5455 rear linkage problem with mower conditioner

    Much appreciated for info, yer this is probably culprit. Does this shaft knock through? Or does whole top have to be removed of back end etc? Years since iv worked on something like this.
  17. Re: Mf 5455 rear linkage problem with mower conditioner

    Is this item easily replaced ? Where exactly is it located? Much appreciated for reply.
  18. Mf 5455 rear linkage problem with mower conditioner

    Just tried putting a mower conditioner on 3 pt linkage of my MF5455 but noticed unless linkage fully raised, it allows arm to go down on heavy side and other to rise up on lighter side?
    Didn't...
  19. Replies
    4
    Views
    2,502

    Re: Matbro 250 110 axles

    Hmm, wrong oils can defy cause havoc, on a slightly different type of machine i had, a previous owner had put ATF fluid in gearbox/clutch as reckoned made it far more responsive.... within a short...
  20. Replies
    4
    Views
    2,502

    Re: Matbro 250 110 axles

    Id try switching 4wd of and make sure diff locks not engaged when on hard ground, also make sure electrical circuit for operating this actually works as sometimes solenoids can fail in the function...
  21. Replies
    6
    Views
    2,376

    Re: MF 5455 gearbox splitter gear problem

    Case solved, found a male/female spade terminal under floor mat where main wiring loom comes thr cab floor and up to controls area, connector had come adrift, was prob just teetering for long enough....
  22. Replies
    6
    Views
    2,376

    Re: MF 5455 gearbox splitter gear problem

    Yer, the H & L indication on dash works fine & i can hear the relay clicking so im assuming switches ok. I just cant find where the solenoid is hidden :undecided: Iv changed a couple of...
  23. Replies
    6
    Views
    2,376

    Re: MF 5455 gearbox splitter gear problem

    I will check that, i did notice there are 2 devices on side of back end, just assumed they were “level/pressure” warning type devices. Are uou aware where the solenoid lives for this tho? Seems to...
  24. Replies
    6
    Views
    2,376

    MF 5455 gearbox splitter gear problem

    Howdy there.

    Got an issue with my MF 5455 splitter gear, ie the red button on gear shift not selecting gear, just staying in High all the time, the switch seems fine as the indication on dash...
  25. Replies
    3
    Views
    1,928

    Vicon mower conditioner tight bed

    Hello there,
    i am looking at a 2nd hand mower conditioner which has a “tight bed” ie cutters not tirning freely. Is this an expensive fix or something that can be done with replacing a few easy to...
Results 1 to 25 of 133
Page 1 of 6 1 2 3 4