Results 1 to 7 of 7

Thread: Matbro door required

  1. #1
    Junior Member
    Join Date
    Feb 2017
    Posts
    7

    Matbro door required

    Hi would anyone know where I could get a door for a 98 matbro 250

  2. #2
    Senior Member ACE's Avatar
    Join Date
    Feb 2013
    Location
    Oxfordshire
    Posts
    1,508

    Re: Matbro door required

    Quote Originally Posted by brendan1292 View Post
    Hi would anyone know where I could get a door for a 98 matbro 250

    Probably easier to get hens teeth

  3. #3
    Senior Member Footsfitter's Avatar
    Join Date
    Feb 2013
    Location
    Basingstoke, Hants
    Posts
    2,415

    Re: Matbro door required

    Quote Originally Posted by ACE View Post
    Probably easier to get hens teeth
    Bet theres tons of the side he doesn't want
    The best thing about Facebook is the logout button......

  4. #4
    Senior Member T P's Avatar
    Join Date
    Feb 2013
    Location
    The muddy edge of the biggest puddle in the uk
    Posts
    629

    Re: Matbro door required

    No idea of your location but this chap breaks a lot of Matbro's , worth a call.


    http://www.rmcallistertractors.com/

  5. #5
    Senior Member Footsfitter's Avatar
    Join Date
    Feb 2013
    Location
    Basingstoke, Hants
    Posts
    2,415

    Re: Matbro door required

    Quote Originally Posted by T P View Post
    No idea of your location but this chap breaks a lot of Matbro's , worth a call.


    http://www.rmcallistertractors.com/


    I like the Ozzie Tub Feeder http://www.rmcallistertractors.com/m...tails/?id=1380
    The best thing about Facebook is the logout button......

  6. #6
    Senior Member ACE's Avatar
    Join Date
    Feb 2013
    Location
    Oxfordshire
    Posts
    1,508

    Re: Matbro door required

    Quote Originally Posted by brendan1292 View Post
    Hi would anyone know where I could get a door for a 98 matbro 250
    TR250-110 being a 1998 I assume?

    Full glass steel framed door on them unlike the older ones that only had half glass.

    You could find one off a Terex T250 that should fit, doubt new ones are available from Terex and if they are bet they are a lot of money?

    I have straightened a few and welded them back up put new glass in etc depends how bad they are, normally the welds crack on the frame and the hinges rip off or bend out of the frame.

    if the hinge bends out o the frame and the glass stays in one piece what I have done is cut the bent hinge off the frame with grinder and then reweld it back on to suit, rather than try and straighten it on the frame which normally ends up with a broken glass
    keep a wet rag over the glass so it does not get over hot or it will go pop! (only had one do that but its a gamble you have to take

  7. #7
    Junior Member
    Join Date
    Feb 2017
    Posts
    7

    Re: Matbro door required

    I finally found a door thanks lads I have a spare one now if anyone wants one it is off a burnt out machine

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •