Results 1 to 4 of 4

Thread: MF 65

  1. #1
    agrimax
    Guest

    MF 65

    Am partially renovating a 65 with Multi-Power.Haven't split tractor at bell housing yet as owner hasn't decided what to do yet! MP is slipping(but not all the time) and tractor isn't much use without it working properly.Definitely don't want to weld it up.However,there is a small leak from the clutch housing-a fast drip when warm and engine running.Anyone know if this would be enough to cause slippage? If split,can the system be pressure tested?

  2. #2
    multi power
    Guest

    Re: MF 65

    when i bought a similar machine mp would not always work in high, problem was linkage, bent/worn etc n valve not fully operating

  3. #3
    Orcadian
    Guest

    Re: MF 65

    Sounds like one or more of the slip rings on input shaft has worn and seal isnt up to job of holding back the pressure

  4. #4
    agrimax
    Guest

    Re: MF 65

    Expensive to repair??

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •