Results 1 to 4 of 4

Thread: Claas ares 567 atz gear box calibration

  1. #1
    Junior Member
    Join Date
    Aug 2017
    Posts
    2

    Claas ares 567 atz gear box calibration

    Hello i am from greece and i have a Claas ares 567 atz and i want to calibrate the gearbox.Can someone tell me how to make this?

  2. #2
    Senior Member Recycled's Avatar
    Join Date
    Feb 2013
    Posts
    606

    Re: Claas ares 567 atz gear box calibration

    gearbox warm
    hold in the red button to put gearbox into neutral
    engine up to 1500 rpm
    then lift and hold the shuttle forward and at the same time hold down the diff lock button ( or it could be the 4wd ??)
    after a few seconds the forward revers lights start to flash to show its calabrating .
    let go of the shuttle in the forward position and the diff lock and let it do its stuff until the N starts flashing along with the arrows

  3. #3
    Junior Member
    Join Date
    Aug 2017
    Posts
    2

    Re: Claas ares 567 atz gear box calibration

    Thank you very much!when you say lift means that hold the lifts on up side ?sorry for my english language

  4. #4
    Senior Member Recycled's Avatar
    Join Date
    Feb 2013
    Posts
    606

    Re: Claas ares 567 atz gear box calibration

    the forward /rev shuttle lever

    put it into the forward position but keep your hand under it till the calibration starts then let it go . it should be in the forward position while its calibrating





    if your english isnt that good that probably wont help

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •